{"id":2280,"date":"2020-07-19T11:23:20","date_gmt":"2020-07-19T10:23:20","guid":{"rendered":"https:\/\/homebli.com\/?p=2280"},"modified":"2023-01-12T14:35:13","modified_gmt":"2023-01-12T14:35:13","slug":"logic-washing-machine-error-code-and-fixes","status":"publish","type":"post","link":"https:\/\/homebli.com\/logic-washing-machine-error-code-and-fixes\/","title":{"rendered":"Logik Washing Machine Problems & Fixes"},"content":{"rendered":"
Logik washer owners may experience mechanical or technical problems on their machines because of software failure or mechanical faults. It would help if you were not quick to call your local technician when this happens to you. Instead, look at the error code shown on your washer’s display screen and fix the problem.<\/p>\n
Like other washing machine error codes, logic washer fault codes assume the general public and washer repair specialists have a minimum level of competence to understand these codes. However, most users are not familiar with the logic washing machine error codes.<\/p>\n
This piece will guide you on what each error code means, when it shows and how you will fix the error and restore your washing machine to its normal state. Below are error codes, their cause, and possible solutions for the error. These fault codes have been listed according to the model.<\/p>\n
This error code is indicated by a blinking start\/pause light, and it means that your washer’s door is not shut tightly. It would help if you shut the door of your washing machine tightly to avoid accidents. To fix this problem, you need to open your washer’s door and shut it properly.<\/p>\n
You will know that your door has been shut well when you hear a click. If this does not fix the problem, you need to turn off your logic machine and contact your local technician.<\/p>\n
When your washing machine’s water is below the heater, the pressure of your water supply is likely to decrease, and this error code will appear on the screen of your washing machine.<\/p>\n
This error code is indicated by a blinking program ready light. To correct this issue, you need to ensure your water supply tap has been turned on to its maximum capacity. Check the water supply and ensure it is as expected.<\/p>\n
Your washing machine has been programmed to stop automatically when this problem persists. When this happens, you need to switch the machine off, unplug it from its power source, and reach out to your local technician.<\/p>\n
Both the program and start\/pause light will blink when this error occurs. Instead of immediately calling your local technician, take your time, and inspect the failed pump and the obstructed pump filter.<\/p>\n
Take note of the amount and type of debris that obstructs your pump filter and causes your pump to fail.<\/p>\n
Clean the pump filter by removing the debris and all other forms of obstruction. If this does not help and restore your washer to its normal form, reach out to your local technician.<\/p>\n
This fault is indicated when both the program end light and start\/pause light blink. A faulty heat sensor will make the processes in your washer to stall. Correct this by shutting down your washing machine. Unplug the washer from its power source and shut the tap that supplies water into the washer. Contact a qualified electrician to fix this problem.<\/p>\n